Description
* Universal Length Measuring Machine
* Manufacturer: ADITYA
* Model: Lab Microcal 600T
(Display : PC Based System, Granite Base Model)
Computer for setup sofware : Minimum 4GB RAM, Minimum 500 GB HDD, Minimum 2 serial comport,
10) LMC Software (Version 3.0.0.) Basic Standard Software for Data Management Cal Software (As per enclosed Annexure only) (if any extra requirement of software will be extra cost.)
Thread Measuring Wire Set (For Measurement of Thread Plug Gauge) and (1 pair = 2 wires, 1 full set = 21 pairs of wires), Roundness : 0.0005mm, Hardness : 60 ± 2 HRC
Stylus Dia. 1mm for 2 to 30mm for Id measurement
A Set of 13 Double Sperical Probes for Internal Thread Measurement, (For calibration of Thread ring gauges from M3.5 – M100)
1. T stylus No. 0, Dia. 0.335mm
2. T stylus No. 1, Dia. 0.455mm
3. T stylus No. 2, Dia. 0.53mm
4. T stylus No. 3, Dia. 0.62mm
5. T stylus No. 4, Dia. 0.725mm
6. T stylus No. 5, Dia. 0.895mm
7. T stylus No. 6, Dia. 1.1mm
8. T stylus No. 7, Dia. 1.35mm
9. T stylus No. 8, Dia. 1.65mm
10. T stylus No. 9, Dia. 2.05mm
11. T stylus No. 10, Dia. 2.55mm
12. T stylus No. 11, Dia. 3.2mm
13. T stylus No. 12, Dia. 4mm
Master Ring Gauge Dia.25mm,75mm,90mm, 125mm,150mm
Between center table (for holding between center thread plug gauges)
Vee Holder for plug Gauge
Snap gauge holding attachment
External Measurement Ball Anvil
Gauge Block / Length Bar / Setting Standard holding attachment
Length Bar Holding Attachment up to 600mm only
Plunger / Lever Dial / Bore Gauge (Holding attachment)
Pin Gauge Accuracy ± 1 µm, of Dia. 9.52mm (Qty 2 Nos)
Temperature Indicator for LMC, Sensor having RS232 facility
Half Center 55° & 60° For calibration of Taper Thread Plug Gauges
Accessories for External Micrometer up to 400mm
Qualisyst software: For Thread Gauge (External / Internal)
Reviews
There are no reviews yet.